It was nearly a full house. We had to pull out an extra table so we could fit everyone one in.
First up, my apologies for missing a few peoples projects: someone is building a Raspberry Pi based water sprinkler system that will have a web based front end, another was experimenting with a Raspberry Pi Astro Hat.
Stephen was fully kitted out with fresh gear from Shenzhen: Rigol Oscilloscope, SMD soldering station, dual power supply units and...
First up, my apologies for missing a few peoples projects: someone is building a Raspberry Pi based water sprinkler system that will have a web based front end, another was experimenting with a Raspberry Pi Astro Hat.
Stephen was fully kitted out with fresh gear from Shenzhen: Rigol Oscilloscope, SMD soldering station, dual power supply units and...
a 300W dummy load/programmable battery tester, along with SMD gear, LEDs and a SMD capacitor/resistor tweezers based DM.
The Delta 3D Printer seemed to be busy the whole day:
A quick visit in the morning to the local Jaycar procured some final parts for an Adjustable Power Supply Unit. Off to the left is a freshly painted laser cut housing for the unit.
Some Shenzhen gear: SMD parts and storage units, bountiful LEDs, Shenzhen Makers Faire and Maker Block booklets:
There where a few quick tutorials on using a cardboard stencil and embossing machine:
Getting ready for Christmas - running a sheet of cardboard that's encased in a mould, through a cut and embossing machine:
The final embossed card:
Testing the brains of a home made and designed laser cutter controller:
As well as catching up on some patchwork, a dedicated soul hand rolled 152.5m of silicon covered 26 gauge wire onto a laser cut 35g cardboard spool:
RSS Feed
