SW Makers March 2021 Eaton Meeting

A few people couldn't make it, however there was a good turnout with robots running around and LED's blinking away.

Some laser cut Sashico templates:

The Chip-8 breadboard computer is progressing well:

Someone finished off soldering up a Jaycar electronic dice kit:

The Alphabot2 has had a 18650 Li-ion battery upgrade:

Bunnings sell a compacted foam board, on which I ran some laser cutting tests:

The Arduino Sensor PCB has had most of the sensor software written up for it:

Same with the basic ESP32 RGB LED PCB:

We might see the Raspberry Pi based Z80 controller assembled by the next meeting?