SW Makers April 2021 Eaton Meeting

A bit quiet due to school holidays, but we had lots to chat about and a new member introduced himself. 

Phillip's Chip-8 is progressing:

Rick is building a 3D printed robot:  www.thingiverse.com/thing:2662828

As well as a lot of software development work being done on Alphabot2:

Colourful Bead work:

and some laser cut fabric patterns that have been sewed into place:

I tested some members USB-Micro cables so i could collect some data on a cable-tester-board I am building:

All cables where verified against a milli-ohm meter - this short cable measured very high

I spent a few days designing up a 18650 battery pack add-on for the Alphabot2:

The software for the basic ESP32 RGB Neopixel LED controller has been updated: