14/6/2014 13:00-16:00 - Milligan House, Bunbury
Attendees: Paul Hamilton (PH), Steven Eaton (SE), Phillip Jubb (PJ), Clare Johnston (CJ), Dylan Morris (DM)
Show and Tell:
Paul and Steven brought along their 3d Printers. Stephen demonstrated 3D printer calibration and showed off his latest print job - a carbon fibre body for his quadcopter.
Paul showed off the Adafruit 2.8" LCD touchscreen that was running xwindows on a Raspberry Pi.
The output from today’s 3d Printing calibration tests:
Attendees: Paul Hamilton (PH), Steven Eaton (SE), Phillip Jubb (PJ), Clare Johnston (CJ), Dylan Morris (DM)
Show and Tell:
Paul and Steven brought along their 3d Printers. Stephen demonstrated 3D printer calibration and showed off his latest print job - a carbon fibre body for his quadcopter.
Paul showed off the Adafruit 2.8" LCD touchscreen that was running xwindows on a Raspberry Pi.
The output from today’s 3d Printing calibration tests:
The above LH thin wall test was printed in 0.2mm thick PLA, the two smaller RH cubes are printed with 0.4mm carbon fibre filament.
Dylan had a go at printing a 25mm high tree stump:
Dylan had a go at printing a 25mm high tree stump:
The next meeting will be on Sat. the 12th of July at the same place.
RSS Feed
